This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
firmwareloader [23/01/2018 13:24] pieter [Firmware] |
firmwareloader [30/10/2018 08:56] pieter [Procedure] |
||
---|---|---|---|
Line 19: | Line 19: | ||
[[http:// | [[http:// | ||
=== Device === | === Device === | ||
- | To be able install the firmware, your device needs to be programmed to the correct serial baud rate. Go into the configuration menu of the device, choose to modify the serial port settings and select the baudrate of **57600**. Go back to the measurement mode after it has been set correctly. | + | To be able install the firmware, your device needs to be programmed to the correct serial baud rate. Go into the configuration menu of the device, choose to modify the serial port settings and select the baudrate of **57600**. Go back to the measurement mode after it has been set correctly. This method is not suitable for the power supplies, see next paragraph. |
- | ==== Procedure ==== | + | |
+ | If the firmware load program doesn' | ||
+ | |||
+ | ===== Procedure | ||
When all has been prepared according to the prerequisites: | When all has been prepared according to the prerequisites: | ||
- Make sure the device is started up and connected to the computer. | - Make sure the device is started up and connected to the computer. |