This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
firmwareloader [24/02/2017 12:54] pieter |
firmwareloader [30/10/2018 08:56] pieter [Procedure] |
||
---|---|---|---|
Line 14: | Line 14: | ||
When installed, simply connect the instrument to the USB port of the computer and wait until the message is given the installation is finished. | When installed, simply connect the instrument to the USB port of the computer and wait until the message is given the installation is finished. | ||
=== Firmware === | === Firmware === | ||
- | The latest firmware can be downloaded from this wiki or can be supplied by email on request | + | The latest firmware can be downloaded from this wiki or might be supplied by email ([[support@consort.be]]). Place the firmware file by preference in the folder '(your documents)\Consort\Firmware' |
=== Download === | === Download === | ||
The firmware loader can be downloaded and installed from this link: | The firmware loader can be downloaded and installed from this link: | ||
[[http:// | [[http:// | ||
=== Device === | === Device === | ||
- | To be able install the firmware, your device needs to be programmed to the correct serial baud rate. Go into the configuration menu of the device, choose to modify the serial port settings and select the baudrate of **57600**. Go back to the measurement mode after it has been set correctly. | + | To be able install the firmware, your device needs to be programmed to the correct serial baud rate. Go into the configuration menu of the device, choose to modify the serial port settings and select the baudrate of **57600**. Go back to the measurement mode after it has been set correctly. This method is not suitable for the power supplies, see next paragraph. |
- | ==== Procedure ==== | + | |
+ | If the firmware load program doesn' | ||
+ | |||
+ | ===== Procedure | ||
When all has been prepared according to the prerequisites: | When all has been prepared according to the prerequisites: | ||
- Make sure the device is started up and connected to the computer. | - Make sure the device is started up and connected to the computer. |