This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
online_manuals [30/01/2015 09:29] pieter |
online_manuals [17/12/2018 09:06] pieter [Inputs] |
||
---|---|---|---|
Line 2: | Line 2: | ||
===Introduction=== | ===Introduction=== | ||
- | This instrument is manufactured with the latest technology and needs no | + | These instruments are manufactured with the latest technology and need no |
- | particular maintenance. Consort certifies that this instrument was thoroughly | + | particular maintenance. Consort certifies that the instruments were thoroughly |
inspected and tested at the factory prior to shipment and found to meet all | inspected and tested at the factory prior to shipment and found to meet all | ||
requirements defined by contract under which it is furnished. However, | requirements defined by contract under which it is furnished. However, | ||
dimensions and other physical characteristics may differ. | dimensions and other physical characteristics may differ. | ||
- | The normal operating temperature should be between 0° and 40°C. Never use the | + | The normal operating temperature should be between 0° and 40°C. Never use an |
instrument in a room with high humidity (>95 %) or at very low temperatures | instrument in a room with high humidity (>95 %) or at very low temperatures | ||
(condensation water!). | (condensation water!). | ||
===Manufacturer=== | ===Manufacturer=== | ||
Consort bvba\\ | Consort bvba\\ | ||
- | Parklaan 36\\ | + | Hertenstraat 56 unit 9\\ |
B2300 Turnhout\\ | B2300 Turnhout\\ | ||
Belgium\\ | Belgium\\ | ||
Line 44: | Line 44: | ||
===Inputs=== | ===Inputs=== | ||
The measuring electrodes should be connected to the corresponding coaxial | The measuring electrodes should be connected to the corresponding coaxial | ||
- | pH/mV or EC connectors. Automatic temperature compensation and temperature | + | pH, mV, DO or EC connectors. Automatic temperature compensation and temperature |
measurements are possible by plugging a Pt1000 temperature probe into the °C | measurements are possible by plugging a Pt1000 temperature probe into the °C | ||
terminals. Without Pt1000, the manual temperature compensation is | terminals. Without Pt1000, the manual temperature compensation is |