To Consort website  |  Print page

User Tools

Site Tools


ec_troubleshooting

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
ec_troubleshooting [13/03/2017 13:44]
pieter
ec_troubleshooting [20/08/2019 07:03]
pieter [Introduction]
Line 4: Line 4:
   * Use the right electrode for your application (see  [[http://www.consort.be/Support/Technical_documentation/TAF_TableConductivityCells.pdf|Selection Guide]]).   * Use the right electrode for your application (see  [[http://www.consort.be/Support/Technical_documentation/TAF_TableConductivityCells.pdf|Selection Guide]]).
   * Always clean the electrode after use with an appropriate method (see [[http://www.consort.be/Support/Technical_documentation/TAF_Cleaning_EC.pdf|Cleaning Methods]]).   * Always clean the electrode after use with an appropriate method (see [[http://www.consort.be/Support/Technical_documentation/TAF_Cleaning_EC.pdf|Cleaning Methods]]).
-  * Store the electrode properly when not in use. It is best to keep the measurement surface wet so that the electrode is immediately ready for use. Place it in distilled water with some detergent added.+  * Store the electrode properly when not in use. It is best to keep the measurement surface wet so that the electrode is immediately ready for use. Place it in distilled water with some detergent added.
   * Be aware of mechanical impacts.   * Be aware of mechanical impacts.
      * Avoid to drop the electrode, use an electrode holder where possible.      * Avoid to drop the electrode, use an electrode holder where possible.
Line 26: Line 26:
   * Water samples and products are subject to changes in conductivity due to evaporation. Close all containers immediately after measurement.    * Water samples and products are subject to changes in conductivity due to evaporation. Close all containers immediately after measurement. 
   * Use fresh and clean calibration solutions.    * Use fresh and clean calibration solutions. 
-  * Choose calibration values which are close to the expected measurements.+  * Choose calibration values that are close to the expected measurements.
  
  
ec_troubleshooting.txt · Last modified: 20/08/2019 07:04 by pieter